Summa Cutters

Summa cutters must be set to use the Summa Port after the driver that was provided by the Summa has been installed and a Summa cutter has been added to the Vinyl Spooler.

This is easy to set up in the Vinyl Spooler. First make sure the cutter is switched on, has vinyl loaded and ready to cut a test file.

Next install the Summa driver that came with the cutter (if you haven't already done so) and open the Vinyl Spooler.

You can open the Vinyl Spooler from the File (menu) > Cut/Plot > Vinyl Spooler.

In the Vinyl Spooler, click on the:

1. Connection tab (top right corner).
2. Click Add and follow through the Setup Wizard or Gateway to add the Summa model you have.
3. Once installed restart the Vinyl Spooler and click on the Connection tab.
4. Then from the Connection Method select Port Type > Windows Port from the drop down.
5. Then in the Settings below select Summa Port.

Once this is completed the cutter should now work.