Published on: 23-Aug 05:24am
The rotation and/or mirror can be set from the Vinyl Spooler. First make sure the cutter is switched on, has vinyl loaded and ready to cut a test file.
You can open the Vinyl Spooler from the File (menu) > Cut/Plot > Vinyl Spooler.
In the Vinyl Spooler, click on the:
The default is X,Y however your cutter may cut in the correct position (as shown in the Preview tab of the Vinyl Spooler) using a different Origin Mode.
To test this, go back into the Vinyl Spooler and expand the Repeats folder on the left side and select Orientation test.
If this is unavailable type in a letter "F" in the Software and send this to the Vinyl Spooler to cut out. Cut out the orientation test or the letter "F" and if it is rotated or mirrored follow the steps above and try each of the other three Origin Modes until the letter "F" cuts correctly or the Orientation test number matches the selected mode in the list.
Looking for anything specific article which resides in general queries? Just browse the various relevant folders and categories and then you will find the desired article.Contact Us